[Holla]

Sveiki,

Problema, kad kartais nuspaudus gazą iki dugno, auto labai lėtai greitėja, lyg gazas nebūtų nuspaustas. O kartais viskas gerai. Srauto matuokles atjungti nebandžiau.

Tikrinant klaidas su DelphiCar (ne su STAR) gaunami klaidų pranešimai. Kokios jūsų preliminarios rekomendacijos tvarkymui:

Diesel (611.962 - CDI 2 - MT/AT - 203.006/206/706)
P1481 - Glow plug
P0100 - Air mass meter (hot film)
P1664 - Electronic heater booster

Brake (ESP/BAS (Electronic Stability Program) - ESPMK25 (Electronic Stability
Program) - MT/AT)
C1038 - Engine control module; not identified/incorrect control module
- Intermittent
C1022 - CAN communication with the engine system is faulty
- Intermittent
C1210 - +30 voltage, below lower threshold
- Intermittent

Instrument (Instrument - KI203 - MT/AT)
B110D - CAN; communication fault with control unit AAC pushbutton
- Intermittent

Climate (Climate control - KLA203 - MT/AT)
B15A8 - Footwell flap actuator; left and right is blocked/stiff
- Intermittent

Gearbox (Gear selector - EWM203 (Gear selector) - AT)
P2000 - Braking torque from the traction system over CAN bus; implausible

Multifunction (SAM - Front (Signal Acquisition and Control Module - Front ) -
SAMV203 - MT/AT)
B1003 - Heating water circulation pump; open circuit or Short circuit to ground
- Permanent
B1040 - Control module ICM is not transmitting any data.If fault code occurs with no
complaint reported and no malfunctions, erase fault memory and perform a
function check
- Permanent
B1029 - Control module AAC is not transmitting any data.If fault code occurs with no
complaint reported and no malfunctions, erase fault memory and perform a
function check
- Permanent
B1012 - Left foglight
- Permanent

Multifunction (SAM - Rear (Signal Acquisition and Control Module - Rear) -
SAMH203 (Signal Acquisition and Control Module - Rear) - MT/AT)
B1072 - Right license plate lamp; short circuit or open circuit
- Permanent
B1056 - Center high-mounted stop light; short circuit or open circuit
- Permanent
B1089 - Fault in CAN communication with control unit Instrument cluster. If fault code
occurs with no complaint reported and no malfunctions, erase fault memory and
perform a function check
- Permanent
B1094 - Fault in CAN communication with control unit Right front door. If fault code
occurs with no complaint reported and no malfunctions, erase fault memory and
perform a function check
- Permanent
B1091 - Fault in CAN communication with control unit AAC pushbutton. If fault code
occurs with no complaint reported and no malfunctions, erase fault memory and
perform a function check.
- Permanent
B1085 - Fuel gauge sensor, left and (or) right half of tank; short circuit or open circuit.
- Permanent

Multifunction (Upper control panel - OBF203 (Upper control panel) - MT/AT)
9021 - CAN: communication fault with IC (Instrument Cluster)
- Permanent